RC Tank Warfare community hobby forum

Here it is with both sides in place



Alwyn

Looking good Alwyn, I’ve one more tyre to print then I’ll be back on with it
Cheers
Wayne


Sent from my iPhone using Tapatalk

I'll bet you're 'tyred' of that TPU hey

Alwyn

Rolling round on floor lol


Sent from my iPhone using Tapatalk

I kept looking at the headlights and didn't like the shape, they needed a rounded part at the back, so I designed some rear covers for the headlights


Busy busy busy

Alwyn

Yay, I’ve just about caught you up Alwyn, a little painting done today
Cheers
Wayne



Sent from my iPhone using Tapatalk

This is the bit where Alwyn says 'I just realised that the hull is the wrong width, and the suspension is incorrect - so I will redesign them'

Hope not lol


Sent from my iPhone using Tapatalk

OH DEAR.... Wayne I always leave the painting until last as you can't stick plastic to paint....

You may have to sand the paint off the bits that you are glueing together in order to get a good join, that's why my tank is totally unpainted at the moment as there are loads of bits still to glue on.

Anyway it's great to see you making such good progress, the hull looks spot on, but I strongly advise against paining the upper hull until nearer completion.

Alwyn

Upper hull is paint free, phew!
I know I’ll have to scrape off wher the suspension goes but an opportunity arose today & I had to take it lol
Cheers
Wayne


Sent from my iPhone using Tapatalk