Page 13 of 111
Re: Bristol Armoured Division
Posted: Mon Mar 14, 2016 5:43 pm
by wibblywobbly
Ok, I have contacted the organiser's, and will await their reply.
..and just to prove that I don't watch daytime tv...
...and this now self centres.
...and the 1/16 jeep project is well underway.
- jeep.jpg (40.71 KiB) Viewed 2597 times
and tomorrow I might build a couple of Jagdpanther IV's, they don't take five minutes so I'll knock up a couple and see what they look like!
Re: Bristol Armoured Division
Posted: Mon Mar 14, 2016 6:03 pm
by silversurfer1947
Great stuff.
Re: Bristol Armoured Division
Posted: Mon Mar 14, 2016 6:14 pm
by Bogeyman
Very good Rob, and for your next trick
?
Re: Bristol Armoured Division
Posted: Mon Mar 14, 2016 10:53 pm
by wibblywobbly
The show invitations will be going out at the end of the month, and they we will be welcome. I will let you all know more as soon as I know.
Rob
Re: Bristol Armoured Division
Posted: Thu Mar 17, 2016 5:45 pm
by wibblywobbly
If anyone by the name of Andy ever says to you 'here, take this Tiger and see what you can do with it'....poke him in the eye with pointed stick and run, keep running, do not stop, not for anything!
....to be continued....
Re: Bristol Armoured Division
Posted: Thu Mar 17, 2016 5:57 pm
by silversurfer1947
It's already changed out of all recognition!!
Re: Bristol Armoured Division
Posted: Thu Mar 17, 2016 9:27 pm
by TKcommander
I had to poke myself in the eye to make sure I was seeing things correctly!!!!!!!
Re: Bristol Armoured Division
Posted: Thu Mar 17, 2016 9:34 pm
by silversurfer1947
I hope the stick wasn't too pointed
Re: Bristol Armoured Division
Posted: Fri Mar 18, 2016 5:26 pm
by wibblywobbly
Its not often that I post pictures of my rear end on a forum but here we are anyway!
...to be continued...
Re: Bristol Armoured Division
Posted: Fri Mar 18, 2016 5:44 pm
by wibblywobbly
1/18 vs 1/16
After a lot of faffing about I finally got two halves of a 1/16 jeep, it will be faced up with 0.5mm styrene which will make it 1mm oversize, but hey, that's my stupid fault for concentrating so much on cutting the model into two halves and reducing the print time as much as possible. This mess still took 6 hours! To print a solid bodyshell would have taken 18??