RC Tank Warfare community hobby forum

The colours turned out to be slightly different on the Schurzen compared to the tank.
That is due to the difference in material.
Hull is ABS plastic while the Schurzen are aluminum.
But I am satisfied anyway

It looks super. Now wash all and use for exemple army painter anti shine matt and it will be no diference

That looks really good! A bit of weathering and it's done!

Going to look at similar for mine sometime, but still fitting the op board and bits to it


Sent from my iPhone using Tapatalk

Lo_Thar wrote:It looks super. Now wash all and use for exemple army painter anti shine matt and it will be no diference

I painted the Schurzen with Humbrol enamel paint.
Will the wash you mentioned stick onto my paint?

less Schurzen



image hosting

Next little project on this F Type will be adding some handles onto the commanders hatch so he will be able to open/lock it from the inside.
Any ideas are welcome....

Lo_Thar wrote:It looks super. Now wash all and use for exemple army painter anti shine matt and it will be no diference

Looked it up on the internet, available for €2.50 but on top comes €5,95 shipping.
A no go.
Must wait till I am near the German Hobby shop again, so at least I can save me the shipping cost.
And use for €6.00 fuel to get at the shop, hahahahahahha!