RC Tank Warfare community hobby forum

Almost finished.

Every home should have one !!
Mine especially
Watching closely on this one

Could I be a little cheeky and ask for one as I've been looking for either a BS-3 100mm or a ML-20 152mm for my YA-12 artillery tractor

I will be equally as cheeky then !!
Looks like you have orders mate

I can put it up on Thingiverse when I know it all works together, then you can get someone local to print it for you, my printer is old and slow (just like me) compared to modern stuff. I'm in the process of test printing at the moment so shouldn't be too long.

JohnWhyte wrote: ↑Sat Nov 08, 2025 11:41 pm Could I be a little cheeky and ask for one as I've been looking for either a BS-3 100mm or a ML-20 152mm for my YA-12 artillery tractor

YA-12 artillery tractor, where did you get that ?

A few test prints to see if everything fits together ok.

Moogie wrote: ↑Sun Nov 09, 2025 1:13 pm
YA-12 artillery tractor, where did you get that ?

I picked it up a while back of eBay it's a scratch build on the Panzer 3 hull

Also is it FDM or resin printing you using

JohnWhyte wrote: ↑Mon Nov 10, 2025 9:12 am

Moogie wrote: ↑Sun Nov 09, 2025 1:13 pm
YA-12 artillery tractor, where did you get that ?

I picked it up a while back of eBay it's a scratch build on the Panzer 3 hull

Also is it FDM or resin printing you using

Both, i dont think you would get the details with just fdm.

I'll have to ask around then as I only have a resin printed then