RC Tank Warfare community hobby forum

I've had a dig around in my spare parts and I don't seem to have one. My T-55 is due for some work though so I'll find some time over the weekend to take one off of it and get some measurements for you.

No problem B man.

Apologies for the delay Moogie, I had some family drama to deal with over the weekend. I've pulled my poor old neglected T-55 apart and attempted to remove a swing arm but it's proving to be very challenging and I don't have a lot of faith in the Hooben metal so will do my best to measure while it's still installed.

1 - 8mm with of arm. Slot is 9mm long by 3.5mm wide
2 - 9mm between the inside of the two axels
3 - 6mm diameter and nub is 2mm
4 - depth of arm was difficult to measure accurately but I'm guesstimating it at 16mm

Shout out if you need any others. I need to install a hull plate and a few other bits to get it running properly so it will likely be in bits for a while.

Thank you very much B Man.