RC Tank Warfare community hobby forum

Hello Mr.Bix,
Are you talking about a V 7.1 card? Wouldn't that be TK 7.1? Or I didn't understand anything

your question? Does it concern this?

That’s an actual HL set

This is the one I’m struggling with.
For a HL V7.1 control board https://www.ozarmour.com.au/store/elect ... XCkMyCqufY

Already found this, but surely something is missing? because there are empty socket numbers? but maybe not? to see. But maybe this will give you a little help? Perhaps a universal system, for general connection? there seems to be a single wire (negative LED) and also for combat indicated "Infrared Emitter" I would say that the general power supply? would be the 2-pin socket, at the top left of the socket, since the negative LED arrives there, a photo of the bottom of the socket would help? How many pins does the center plug have?

Hello Mr. Bix, following various research, I would say that your turntable with many plugs? is designed for a 360° rotation system connection? hence the presence of the large white plug in the center, that's what I found on the net. Personally I think it should work as is? after making sure where the main power supply is (+/-) see below CI if not indicated?

Another simpler system?

There are many different ones, which in the end must amount to the same thing, depending on what is connected

https://www.google.com/search?q=smoke%2 ... =690&dpr=2

Well, without certainty? but in view of the diagram of the V 7.1 board and the thin diagram of the smoker, I deduce that the flash (which must be a LED) would be connected to one of the sockets since CN 6 being (Trigger switch) inter control of the cannon and flash firing, and I suppose that CN 15 (infrared Emitter) the power supply of this board? Now on the V7.1 there is also CN 14 indicated as (Extension function interface) but nothing indicated on the smoker diagram? for possible junction ....

I didn’t even consider CN14
I will open thrr we hull over this weekend and see it it allows a flash option.
Just be a whole lot easier to use the HL version.
The MATO one is

Herman, I don't want to say anything stupid? But it doesn't seem to me that you can install a Xenon type Flash on this type of card? I would be more convinced that it is a LED? But maybe I'm wrong?

Jofaur86 wrote: ↑Fri Feb 14, 2025 6:27 pm Herman, I don't want to say anything stupid? But it doesn't seem to me that you can install a Xenon type Flash on this type of card? I would be more convinced that it is a LED? But maybe I'm wrong?

Any option would be good!
The 7.1 board offers a port to instal a flash direct to it but as the negative pole in this port is already occupied by a single pin from the Mato system I cant use it.