RC Tank Warfare community hobby forum

I so want to play with the single motor dual clutch gearbox (Sassgrunt supplied me with one). But simply stated the new stuff if so much better. I love the mechanical portion of these builds (my soon to be announced cooperative build with Monsieur Tox should explain).

Yeah I was going to replace it with some Torro gearboxes, but it’s just so neat, and I already have a Torro KT already, so I’m going to try to leave it.

Dude (my California raising) please do what you will! Some day I will figure out the right way to use that gear box.

Hello, personally I kept it in a safe place, because it is a beautiful mechanism

for information, and in post download of this Forum "assembly instructions "KT first generation"
https://www.rctankwarfare.co.uk/downloa ... h=c98762b7

Hello, following the construction of the Tam, first generation, attached below, I had imagined a setback and elevation by servos? finally chosen made easier, using the Tam. System . the rear part has also been lined with 1.5 mm aluminum

creation of underwings, PVC corners transom reinforcements

the aluminum part is protected with tape, to avoid scratches

replacement of exhaust pipes with 8 mm brass in order to have the possibility to install smoke generator

Jofaur86 wrote: ↑Sun Jun 30, 2024 1:28 pm the aluminum part is protected with tape, to avoid scratches

Fabulous work on the exhaust! But avoiding scratches on a 16th battle tank (not in my wheelhouse).