RC Tank Warfare community hobby forum

Topper if you look at my thread of my Late production tiger I use a lot of the parts from east coast armory. Also don’t forget about the extra armor on the turret roof


Sent from my iPhone using Tapatalk

Hi
Thanks for all the help!!!! My aim is for a basic late war Tiger, something I can modify as time goes by. DasPanzer really nice work, your attention to detail is amazing.

hello, post on this excellent Forum, some advice to improve a Tiger I, and make it compliant at the time
viewtopic.php?f=118&t=11459

Good morning Birger
Thank you for the link, what a valuable resource , your hard work will help countless people like me!!!
Thanks again
Frank

HERMAN BIX wrote:Solid start Mr Topper
Dont forget to remove the unneeded aerial tube from the left/drivers side
You will also need to add a turret ring armoured band that protects the gap between turret and hull, its a late version indicator.

Do you have a specific machine in mind or are you freestylin it !!

unless I'm mistaken? Herman talks about this piece, this one was cut from a sheet of ABS,( reed) I don't think it's all done? so a bit of manual work, also remove that ugly set of molded edge, and replace with metal Good day.

Hello,
For infos
http://www.alanhamby.com/tiger.html

Jofaur86 wrote:Hello,
For infos
http://www.alanhamby.com/tiger.html

An excellent source as is anything Tiger 1 from David Byrden

Morning
Some of the part arrived this morning, just waiting for the electronics , how do I remove the cupola? I looked inside the turret and there aren't any screws holding it but its really stuck on,
All the best and thanks for all the help!!!
Frank

Topper wrote:Morning
Some of the part arrived this morning, just waiting for the electronics , how do I remove the cupola? I looked inside the turret and there aren't any screws holding it but its really stuck on,
All the best and thanks for all the help!!!
Frank

Place the blade of a screwdriver/penknife through the viewing slit of the cupola and gently I SAID GENTLY Lift the blade,
Remove the blade and place it in the opposite viewing slit and again GENTLY LIFT the blade,
You should hear the crack of the glue failing,
Lift the cupola off and note the locating hole for the placing of the replacement cupola.

Thanks jarndice
I would have never of though of that, can you tell me how the MG42 is attached please?