RC Tank Warfare community hobby forum

Jhamm yes my friend .Also i don't want to cause any other mulfuction. Maybe i can do it if u explain with simple words how to do it

????? ?? SM-N950F ???????????? Tapatalk

1. take your Transmitter an turn it on.
2. take the receiver and turn it on
3. take a servo and plug it into channel 1
4. look which stick or switch let move the servo
5. do this in sequence with all channels
then you know which stick and switch
which channel is assigned
does this agree with the instructions?
does it not fit, then plug the channels in the appropriate order to the IBU.
which channel / function belongs to which input
is described in the instructions for IBU

And why plug the servo at channel 1 ? The switch that causes the problem is SWA : channel 5

????? ?? SM-N950F ???????????? Tapatalk

My board is with one something like that. Only one wire to the receiver/ board. It's like the receiver at the photo

????? ?? SM-N950F ???????????? Tapatalk

This is a i-bus connection.
it would have been good to have had this information beforehand.
Because this, i think there will be an error in the IBU configuration.
Did you know the IBU Manual?
http://www.ibu-electronics.com/doc/IBU2 ... h_V2-3.pdf
Look at "Getting Started" and do all steps again..

? Know the IBU manual but i got them already set and programmed by my supplier. But i can fix if i know what some things

????? ?? SM-N950F ???????????? Tapatalk

My first language is not English so maybe it is a little difficult than u. But I want to try carefully not cause any other problems

????? ?? SM-N950F ???????????? Tapatalk

Also i did radio Calibration once yesterday

????? ?? SM-N950F ???????????? Tapatalk

These are ok i think so

????? ?? SM-P605 ???????????? Tapatalk