Page 2 of 2
Re: New switch for my tank
Posted: Wed Oct 23, 2019 11:59 pm
by Son of a gun-ner
Re: New switch for my tank
Posted: Thu Oct 24, 2019 8:43 am
by jarndice
Roys photograph does not show the end of the cable,
It is not a simple 2/3 pin JST plug that the usual power switch has that simply plugs into the MFU,
This is a multi-cable that ends in 2 plugs and one of them goes into your receiver which means this switch will not work with a Taigen or Heng Long set up only with an aftermarket radio.
Re: New switch for my tank
Posted: Thu Oct 24, 2019 10:54 am
by 43rdRecceReg
jarndice wrote:Roys photograph does not show the end of the cable,
It is not a simple 2/3 pin JST plug that the usual power switch has that simply plugs into the MFU,
This is a multi-cable that ends in 2 plugs and one of them goes into your receiver which means this switch will not work with a Taigen or Heng Long set up only with an aftermarket radio.
I do beg your pardon, Shaun, for coming up short.

I was about to invite you to post a pic of the other, elusive, half (most pics only show the on/off end). But, I shall save you from an impossible task with this wee snappette:

- Skyrc On-Off switch with lipo function
Incidentally, these meddlesome predictive text tools converted 'lipo' to lips'. Good thing I checked..

Re: New switch for my tank
Posted: Thu Oct 24, 2019 4:48 pm
by desmo16
Guys how can you upload photos?
Re: New switch for my tank
Posted: Thu Oct 24, 2019 6:49 pm
by 43rdRecceReg
desmo16 wrote:Guys how can you upload photos?
Ensure that your pics are no larger than 351kb (something like a tad less than 1920((W)) x1080 ((H)) pixels). Just click on the 'upload attachment' button (as you did before ?), and point the browser to the whereabouts of the photo you want to upload. You can also use 3rd party sites to post pics (Imgur, for example). Hope this helps.
Re: New switch for my tank
Posted: Fri Oct 25, 2019 2:57 pm
by desmo16
Here is the connection made with taigen V3 electronics