Page 2 of 2
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
Posted: Mon Sep 16, 2019 10:40 am
by Dusty Steppes
As a side note the torsion bar parts are also used in Taigen's KV-1 metal chassis and are interchangeable.
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
Posted: Mon Sep 16, 2019 10:54 am
by Son of a gun-ner
Dusty Steppes wrote:As a side note the torsion bar parts are also used in Taigen's KV-1 metal chassis and are interchangeable.
I wouldn't be surprised if they were the same in their other tanks.
I'm very disappointed in these parts, they appear to be a cast light alloy, they really aren't up to the intended job.
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
Posted: Mon Sep 16, 2019 8:21 pm
by midlife306
HERMAN BIX wrote:Its not true what they say about you Mr Gunner
Ohhhh yes it is lol
Sent from my iPhone using Tapatalk
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
Posted: Mon Sep 16, 2019 9:02 pm
by ronnie42
Could you not use this as a fix. Cut a brass or Al tube longer than the pot metal torsion bar holder fit it instead of the short brass sleeve and fill with Jb weld epoxy.