TAIGEN TIGER 1 TORSION BAR ANCHORS
Forum rules
RULES LAST UPDATED 25/03/2019
Please make sure you are up to date with the Wanted section rules and guidelines before creating a new post. You can find them here: viewtopic.php?t=27359
RULES LAST UPDATED 25/03/2019
Please make sure you are up to date with the Wanted section rules and guidelines before creating a new post. You can find them here: viewtopic.php?t=27359
-
Dusty Steppes
- Private
- Posts: 74
- Joined: Sun Jan 26, 2014 10:51 pm
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
As a side note the torsion bar parts are also used in Taigen's KV-1 metal chassis and are interchangeable.
-
Son of a gun-ner
- Lieutenant-Colonel
- Posts: 7462
- Joined: Sun May 07, 2017 8:49 pm
- Location: Lancashire UK
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
I wouldn't be surprised if they were the same in their other tanks.Dusty Steppes wrote:As a side note the torsion bar parts are also used in Taigen's KV-1 metal chassis and are interchangeable.
I'm very disappointed in these parts, they appear to be a cast light alloy, they really aren't up to the intended job.
Mick - The grit in the underpants of life!
Always happy to spare the bytes
Apparently my mind works in mysterious ways
TOTM needs YOU
support YOUR TOTM competition, I'm doing my part, are YOU?
Always happy to spare the bytes
Apparently my mind works in mysterious ways
TOTM needs YOU
support YOUR TOTM competition, I'm doing my part, are YOU? -
midlife306
- Warrant Officer 1st Class
- Posts: 2238
- Joined: Sun Aug 27, 2017 10:34 am
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
Ohhhh yes it is lolHERMAN BIX wrote:Its not true what they say about you Mr Gunner
Sent from my iPhone using Tapatalk
Re: TAIGEN TIGER 1 TORSION BAR ANCHORS
Could you not use this as a fix. Cut a brass or Al tube longer than the pot metal torsion bar holder fit it instead of the short brass sleeve and fill with Jb weld epoxy.
