Page 2 of 2
Re: identify rx 14 or rx 13 board from box?
Posted: Mon Oct 20, 2008 9:00 pm
by mickyb
Hi,
I will shortly be fitting an RX 18 and El-mod into my Tiger, If you need a RX14 board you are welcome to mine when its removed. I have been helped by everyone since I joined a few weeks ago so this will be a little bit of pay back.
Mike
Re: identify rx 14 or rx 13 board from box?
Posted: Mon Oct 20, 2008 9:05 pm
by Norse
mickyb wrote:
Hi,
I will shortly be fitting an RX 18 and El-mod into my Tiger, If you need a RX14 board you are welcome to mine when its removed. I have been helped by everyone since I joined a few weeks ago so this will be a little bit of pay back.
Mike
Mike dont forget you need 2, 2 pin connectors for the motors, 1 2pin connector for the power and a 3 pin connector for the volume control
Re: identify rx 14 or rx 13 board from box?
Posted: Mon Oct 20, 2008 9:08 pm
by Matdragon
mickyb wrote:
Hi,
I will shortly be fitting an RX 18 and El-mod into my Tiger, If you need a RX14 board you are welcome to mine when its removed. I have been helped by everyone since I joined a few weeks ago so this will be a little bit of pay back.
Mike
hi mickyb, i may get one of this tank and try my luck, and if i get a 13 then i will most certainly contact you! and a small payment will be enforcesd LOL
thankyou very much for the offer!,
cheers again,
Matt