RC Tank Warfare community hobby forum

I think it’s left stick down bottom right & hold it there for a few seconds


Sent from my iPhone using Tapatalk

Hi Midlife I have tried bottom left and all other diagonal corners blue light flashes as if something is opperating but no sounds or movement.

Try recalibrating again. When you hold it in the corners it has to stay there for 5 seconds. Or assign engine start to a switched channel on the radio.

Make sure the trims on the TX are centered. On my IBU2s start is up and right. Hold it for a slow 10 count, just to be sure.

Hi guys. Time this evening to try the IBU2 again.

Re-calibrated swapping turret and drive sticks over still no engine sound or motor movement, then did it again back to normal controls. But still no engine sounds or motor movement.
Have emailed Tankbear I know he is recommended on here.

Bill what radio are you using?

c.rainford73 wrote:Bill what radio are you using?

I think I know where you're going with this
Is it to do with the positioning of the top switches with start up?

Yes and no Mick. I'm curious as I've got mine setup on the turnigy 9x radio and assigned the engine start stop to a channel with a switch. Very simple to do using the sd card.

Once you go into the settings just assign engine start to a specific channel and go!

c.rainford73 wrote:Bill what radio are you using?

Hi .
I am a Turnigy X9 radio.

Go into the SD card and assign engine start stop to either channel 5 or 6 the switches and give it a go.