RC Tank Warfare community hobby forum

Yay, you can’t beat a bit of luck now an again
Cheers
Wayne


Sent from my iPhone using Tapatalk

progress:
modeled in the torsion suspension stop bumps
reworked the gun elevation housing
added details on roof and slots for the top parts to fit in. such as periscopes and also antenna slot.

added more details to the hatch and it's slot fitting
added rear machine gun detail
added hinges to travel lock
added hinges to engine door
reworked gun elevation guide for better gun shield travel clearance

i need your input on what type of servos to be put into for the gun's elevations and recoil.

this one is without the hull side panel

I use the MG90s, I’m sure others will be along with their preferences
MG90S Metal Gear Micro High Speed Servo For Plane Helicopter Boat Car 4.8V-6V https://rover.ebay.com/rover/0/0/0?mpre ... 2507901263

Cheers
Wayne


Sent from my iPhone using Tapatalk

would you guys want the file in SKP format so you can edit it on the PC or just straight STL files?

Hi,
As I’m a simpleton I think I’d need STL files, but I’m sure others would prefer the SKP file.
Is there any way you could share both?
Cheers
Wayne


Sent from my iPhone using Tapatalk

midlife306 wrote:Hi,
As I’m a simpleton I think I’d need STL files, but I’m sure others would prefer the SKP file.
Is there any way you could share both?
Cheers
Wayne


Sent from my iPhone using Tapatalk

i'd need your printer print size. would need to slice the hull wall probably in 2 pieces