RC Tank Warfare community hobby forum

I take that back, it says it has a 3 meter wheel base.

Many thanks Alwyn, there is one on Thingiverse, I scaled it up, but it would be a 'very' long print, 2-4 days depending on quality etc. Will have to think about that or design my own that will print in a fraction of that time.

oooops! it seems that i didn't read too well the model name

I’ve this..

It’s scaled up from that model on Thingiverse & completely hollow.
Cheers
Wayne


Sent from my iPhone using Tapatalk

The length variables are down to stowage specification on the rear, they all had a winch just below the towing hitch.
Cheers
Wayne


Sent from my iPhone using Tapatalk

Even printing it hollow it is showing as a 1-2 days print time, which would be a pain. How long did yours take?

Just short of 2 days, but that was all the individual parts, I’m going to extend the rear for fuel tank spare wheel & stowage


Sent from my iPhone using Tapatalk

I might have a go at designing one, I have some time as I am awaiting some more filament anyway.

This is what I worked from

Cheers
Wayne


Sent from my iPhone using Tapatalk

Some more inspiration




This is one I found that shows the chassis was used for lots of things...


Cheers
Wayne


Sent from my iPhone using Tapatalk