Page 2 of 2
Re: Need help, looking for rubber strips for my M1 Abrams bu
Posted: Sat Aug 19, 2017 12:15 am
by c.rainford73
BarryC wrote:Just found a listing on ebay that was not there yesterday when I searched. It is way more than I need 12"x 19.5" but it is only .02" thick.
It is 55A Shore Hardness so it is a little stiffer than I would like but it is black, so I'm going for it!
Barry
Nice work Mr Barry
can't wait to see what you do with that stuff. On a side note did you order all the bits for the firefly build? Are you going to post some staring pictures soon? Enjoy your work and looking forward to that one for sure
Re: Need help, looking for rubber strips for my M1 Abrams bu
Posted: Sat Aug 19, 2017 12:24 am
by BarryC
They also have .4mm which will be very close to .250" scale inches.
Thanks Mick!
Re: Need help, looking for rubber strips for my M1 Abrams bu
Posted: Sat Aug 19, 2017 12:38 am
by BarryC
c.rainford73 wrote:BarryC wrote:Just found a listing on ebay that was not there yesterday when I searched. It is way more than I need 12"x 19.5" but it is only .02" thick.
It is 55A Shore Hardness so it is a little stiffer than I would like but it is black, so I'm going for it!
Barry
Nice work Mr Barry
can't wait to see what you do with that stuff. On a side note did you order all the bits for the firefly build? Are you going to post some staring pictures soon? Enjoy your work and looking forward to that one for sure
Carl,
I have a thread for the Firefly build already, unfortunately all the photos went with the PB BS! If a get a chance I'll spend some time and repopulate it. Perhaps when I get the Mato Bogies from Dave and get started on it again.
Barry
Re: Need help, looking for rubber strips for my M1 Abrams bu
Posted: Sat Aug 19, 2017 12:49 am
by c.rainford73
Son of a gun-ner wrote:Just don't ask where I first went looking for latex. . . .
Mind you, the name of the site I posted wasn't so discreet lol.
Try explaining a delivery from them to your wife
Mick.
All in the name of fun I guess
Re: Need help, looking for rubber strips for my M1 Abrams bu
Posted: Sat Aug 19, 2017 1:03 am
by BarryC
Son of a gun-ner wrote:Just don't ask where I first went looking for latex. . . .
Mind you, the name of the site I posted wasn't so discreet lol.
Try explaining a delivery from them to your wife
Mick.
I already explained it to her!
Re: Need help, looking for rubber strips for my M1 Abrams bu
Posted: Mon Aug 21, 2017 5:12 pm
by gisalook
You could use the GT2 6mm Timing Belt of a 3D printer. It comes in a few sizes. and its cheep.