RC Tank Warfare community hobby forum

silversurfer1947 wrote:In reply to your initial question, you might find it useful to have a look at this viewtopic.php?f=79&t=23675

If I tie in on a link, it works inverted tower movement and shotgun elevation.

https://www.youtube.com/watch?v=n9222v3 ... e=youtu.be

If I swap 3-4 wires (green, brown) The tower has 8 pin connectors, it works well with tower and cannon lift.
But no shot
Can I kick off bullet shots?
No bullet shot, only the controller give a gunshot sound and the engines back skip?

Hello!
She does not do anything now.
Do not shoot 6 mm bullets, do not pull the gun up. And there is no shooting sound.
I've already tried many variations. No rifle pulling.
Let it just be a cannon sound!
Is this possible?

Yes, this is the common result of this modification.
There is a diagram of how to do this but it's still messy.

And can only be a gunshot sound?
It generates a controller.
What should I do is that I press right button, trailing forward left arm, be a gunshot sound.

Leave the tower and the 8 pin connector.
Can the 4th generation control sound a shot, without airsoft pulling?
So can only be a gun shot sound?
Can anyone answer that?

I have not been able to get just the sound and recoil on any of my new controller tanks. Not like the old style "dry fire" controllers.

Bill

The old and new RX18's do exactly the same with one exception, elevation is two way on the T90 version.

The only way to install the T90 RX18 into the older tanks is to fit the new socket on the underside of the hull (it could be done by re-routing wiring from the 8 pin and some soldering, but most wouldn't want to do that.

http://d13z1xw8270sfc.cloudfront.net/or ... 1-1-4c.jpg

The gun fire sound, hull recoil, and airsoft will not work unless the two pin socket that is attached to two wires that go to the airsoft microswitch is plugged into the top socket. Its the one marked track recoil in the diagram.

This in turn will not work without the new upper hull socket as it routes the current to different shared circuits to the old one.

Ignore the 8 pin wiring in the pic, it relates to the old RX18 not the T90 version.

So, if there is a new distributor, what can I do from the tower's future 3 wires?
For me tank there is 2 wire lamp. 2 wire turret.
3 wire cannon movements, and airsoft.

This is the only way that you can install a T90 RX18 into an older tank.

viewtopic.php?f=79&t=23675