RC Tank Warfare community hobby forum

Hi, Thanks have you any picts of this please . Im out of work at the mo , hence the free time . So I shall have a bash at this tom .
Thanks Andy

still havent got that far yet so sorry no pics but its fairly easy

Hi thanks , If I get it done tom I will post a pict but Ive got a lot to do . Its amazimg out of work buy still got lots to do . Ive zimmereted my back pannel for my Tiger1 as I bought Riks Asiatam bottom half . Correct me if Im wrong but the swing arms look the wrong angle , its a lot higher than my HL bottom ?

Again thanks Andy

heres a dia of the light box 

Hi fv432 ,
I went to poound land today no luck with fibreoptics in my branch . But my mums got a small christmas tree with them on it so I pruned some of . However there not very thick , thanks for the pict . Can the LED be wired to the RX13 board were the front light comes from ( sorry Im no good at electronics ) . But I will put a on of switch ?

Thanks Andy

yes should be ok just check the voltage
off the top of my head its 4.5 volts to the headlights so a led in that range would be good

Hi fv432,
Thanks will check it out , my fibreoptice cables very thin is there veriations in the thickness ?

yes the hdmi cable i use is about 1mm and the next lot i just got which is computer network cable is about 0.5 mm

hi thanks I used cable from an xmas tree . to thine I think will look at HDMI cable,

Thanks Andy

Hi,
Sorry if this sounds a sillt question does it have to be a particular HDMI cable as I got some and there was no fibreoptic cable in it ?

Thanks Andy