RC Tank Warfare community hobby forum

i've just had a go Chris, took no more than 2 minutes, cut it with aviation snips and tapped out the curl on a small vice just need tidying up with a small file, might have a go at making some using brass fret pins as the track mount

regards  Jack.

only problem with me jack is i dont have anything decent to cut with,  those track hangers cost £45 thats without postage from some place in germany

  chris

I'll cut some if you want, can't promise they will be dead on the old sealed beams arnt too good these days .

they need to be bang on 3/32 or 2.5mm to go through the track if not could file them down a bit


      chris

if you want them let me know how many strips, their about 3" long and probably will need tidying with a small file, easy enough with brass

Jack.

thanks jack 6 will do, ill get 2 per strip let me know how much you want incl p&p  i tried to make them with plastic card didnt work out to thick

             
              chris

Just postage Chris, pm me you address when your ready

Jack.

havent done anything to my jagdpanther for over a week bought milliput off evilbay 3rd may to do welding seams still waiting gets very frustrating when i cant buy stuff in this banana republic

    chris