RC Tank Warfare community hobby forum

And just when you thought it couldn't get any worse it did! For goodness sake take care jack, This is the time for some selfishness look after yourself. shaun

Take care of yourself jack like others have said the tiger ain't going anywhere.

Ok got some pics for you guys of my new hybrid Tiger! Hybrid because its built from a little bit of everything.

Taigen metal lower hull...


Hobby Boss early Tiger road wheels, I'm using these plastic or not as they are very finely detailed wheels. Very Nice!...


This is all of the H/L upper hull that will be used, the antenna tube on the left side was already removed the right side has been removed too since this pic was taken in favor of using a brass tube...


The engine hatch has been opened up and made into a working hatch. I scratch made the latch that would hold the hatch open as well as the block that it catches onto on the hull.






The upper hull from the Hobby Boss Tiger was cut so I could splice it into the H/L upper hull, the reason behind this is the Hobby Boss Tiger has the turret set correctly on the upper hull as well as the Hobby Boss Tigers turret is also correct so the rotation of the turret is fixed. The Hobby Boss Tiger's turret also has the mantel shaped correctly so no need to fix it same for the turret shape. So by using the Hobby Boss Tiger's bits it solves several problems at one time! The Hobby Boss upper also has some very nice weld lines so another win! I then cut the driver and co-drivers hatches open so I could use metal Taigen hatches which open and I cut off and removed the jack block that was molded onto the upper and am in the process of smoothing it out with filler putty.


As for the hatches I thinned the mounting pads and thinned the arms down so the hatches open properly.




That's all for now, hope you enjoyed the pics!

Looking good so far jack

Jeez Mr Jack, no holding you back mate
Certainly got the "knock em out-drag em in & carve em up" thing going on
My next Tiger will be 'F05' of the Fehrmann Gruppe so any hints I can get will be real handy.

Herman I'm busy learning too my friend! But thank you.

What mistake? Did I use the wrong color red oxide primer? Dear God I hope not!

I can't see any obvious mistakes except for those weld lines on the hull roof to left and right of the turret. Tigers didn't have joints there.

David

David, are you sure none of them did? The upper is from Hobby Boss which is a very nice kit with good details. If they're not supposed to be there that's easy to fix.

Keiser, cool. Thought I messed something up.

jackalope wrote:David, are you sure none of them did?

Quite sure. The hull roof was made of 2 plates.

David