Page 2 of 2
Re: Vision Ports
Posted: Sun Apr 29, 2018 8:02 pm
by MADRICK42R
no pics
Re: Vision Ports
Posted: Sun Apr 29, 2018 10:35 pm
by 971wright
Hi Most of the older posts lost the photos when forum was hacked.
regards pete
Re: Vision Ports
Posted: Mon Apr 30, 2018 4:49 pm
by wibblywobbly
It's very easy to do, even without pics. The tops of the vision ports should be level with the casting on the hull. Each slit pops out with a screwdriver. You just sand the bottom off so that when they go back in the top each port is level with the casting surround. Glue them in, and then use filler to smooth the edges.