RC Tank Warfare community hobby forum

ALPHA wrote:

Steelhammer wrote: Nope......I've gone right off zimmerit

OK Hammer Leaving only one thing left that requires about the same attention...how do you feel about welds

ALPHA

Haven't tried those just yet

I recall the zimmeritt that I put on a Tiger 1, I deliberately made a less than perfect job of it, and left bare patches so that it looked battle worn, they look pretty good when it looks like the stuff has been knocked off.

I seem to recall that the JP and KT zimmerritt was applied on the front valance using a ladder. This means that they had a pattern left and right of centre, and then they did the centre part when they took the ladder away, that was always slightly different.

Steelhammer wrote:

ALPHA wrote:

Steelhammer wrote: Nope......I've gone right off zimmerit

OK Hammer Leaving only one thing left that requires about the same attention...how do you feel about welds

ALPHA

Haven't tried those just yet

If you haven't you must

ALPHA

I'll have a look at the photo's on here but I think my KT will be staying with factory welds.

Steelhammer wrote:I'll have a look at the photo's on here but I think my KT will be staying with factory welds.

Herman loves welds ...here's his outstanding job

http://www.rctankwarfare.co.uk/forums/v ... 22&t=13399

ALPHA