RC Tank Warfare community hobby forum

That looks awesome Woz!!!!!!!!!!! ....Now how can I put my order in for two sets of that ...I'm serious...

ALPHA

Got to agree with alpha bloody marvellous my good man

Horses45 wrote:Got to agree with alpha bloody marvellous my good man

Put your order in now Horses... they do look very good


ALPHA

Added some bolts and a spot of welding-

Woz wrote:Added some bolts and a spot of welding-

Came out Great Woz... like that better than the resin one I got.... is the printed surface hard to sand down? looks like you used some filler on yours


ALPHA

I used some knifing putty from a car repair shop. The PLA is pretty tough (like resin) so I use putty to fill in the lines they gave it a light sanding so it still has a rough cast look.

Woz wrote:I used some knifing putty from a car repair shop. The PLA is pretty tough (like resin) so I use putty to fill in the lines they gave it a light sanding so it still has a rough cast look.

Good resin or Bad? ...they still look great

ALPHA

Hey Woz.... they got here safe and sound.... going to try to assemble one and see how it fits on Valerie one... Thanks ...and thanks for the fillers they were a nice surprise

ALPHA

Hope you get them on OK-

Here's a quick how to-
http://warrenhudsonmodelling.blogspot.c ... m3-m4.html


I decided to put mine on my Priest

Dr, Woz,
The caps and hinges got here today. Beautiful stuff! Thank you again. These will be put to great use on the Pershing.
warm regards,
Painless

P.S. _Very_ nice Priest ;o)