Page 2 of 2
Re: tamiya mfu and dmd
Posted: Tue Mar 12, 2013 9:20 am
by tomhugill
With the kv-1 mfu you have to set the trim to the full down position and then blip the throttle in full reverse for it to start, I think this is the same as the Pershing.
Re: tamiya mfu and dmd
Posted: Tue Mar 12, 2013 7:08 pm
by sparks
tomhugill wrote:How did you get it replaced sparks?
Hi Tom,
A few e-mails then returned for refund/replacement, I opted for replacement and have had no trouble with it.
Its a couple of years or so back now, but I think we came to some agreement about the return postage, but the way I looked at it, even with paying the postage it was still way cheaper than buying one in UK.
Re: tamiya mfu and dmd
Posted: Tue Mar 12, 2013 7:09 pm
by sparks
tomhugill wrote:With the kv-1 mfu you have to set the trim to the full down position and then blip the throttle in full reverse for it to start, I think this is the same as the Pershing.
Yes, Pershing is like that.
Re: tamiya mfu and dmd
Posted: Wed Mar 13, 2013 9:26 am
by tomhugill
Where were your units bought from?
Re: tamiya mfu and dmd
Posted: Wed Mar 13, 2013 9:54 pm
by sparks
tomhugill wrote:Where were your units bought from?
If that question is for me, then I bought them from Jasons Store (HK) via e-Bay.