Connection to RX-18 board.

[204sailor]

Hi All,I`m new to the forum,and already I have a question regarding a plug connection on the rx-18
board.After some work done to my stug 3 I`m not sure where the two wire plug going to CN3 plugs into. Is it plugged closer to the connector at CN2 or is it closer to the connector at CN4. I`ve forgotten
where I took it out of,and I had labeled all the other connectors except this one.Thanks for any help.

Charlie

[forgebear]

hi there 2 pin right side of cn3 close to cn4 dave

[204sailor]

Thanks Dave, Will do as you said.Only reason for needing help was that Stug performs nice at room
temperatures,but after chilling outside at below freezing temps (prior to running tank in snow) the tank operates erratically.I figured that the rx-18 board had a temp/component problem so I replaced the board and that`s where I lost my way.Thanks again.

[forgebear]

your welcome and by the way they hate the cold lol

[jimlennon]

i think the rc plane is more complex than the tank,right?