Advice re. Adding HL 7.0 barrel smoke

[BulldogDave]

Hi, I'd really like to add barrel smoke to my Bulldog - I've read/watched a few descriptions but I'm still not clear. Can someone please recommend a step by step guide please?

Thanks in advance!

Dave

[Meter rat]

https://www.rctanklegion.com/products/n ... -flash-kit
Shows the 6.0/6.1, but it is the same for 7.0/7.1.

[BulldogDave]

https://www.rctanklegion.com/products/n ... -flash-kit
Shows the 6.0/6.1, but it is the same for 7.0/7.1.

Thank you!

Does the smoke generator have to be live (heating)!all the time or does it heat instantly as the main gun s fired?

[Meter rat]

It heats continuously. It’s the pump which blows the smoke out. It gives out the best smoke after a minute or two of being switched on.

[BulldogDave]

It heats continuously. It’s the pump which blows the smoke out. It gives out the best smoke after a minute or two of being switched on.

Ok thanks that makes sense.

I'll watch the video later once the TV isn't in use by Mrs Dave....

[Jib]

https://www.rctanklegion.com/products/n ... -flash-kit
Shows the 6.0/6.1, but it is the same for 7.0/7.1.

Thank you!

Does the smoke generator have to be live (heating)!all the time or does it heat instantly as the main gun s fired?

So, although this is in my 1/8 scale tank, I am using the same sized heater you would use in a 1/16 scale tank powered at 6V, and it only takes a few seconds to heat up to the point where you can blow smoke out of it.

The board I am using allows me to turn the heater on and off at will, so I only turn it on when I want to show it off, then keep it turned off otherwise.

If you are installing this in a 1/16 HL and want to keep your Airsoft unit, here is a video I made on how to do that.

https://youtu.be/VpHASKt_4fw?si=gnY8MaFTshEVzUO6