Super glue

[Stormbringer]

Annoying when you grab the super glue and its gone off in the tube/bottle
But if you keep it in the fridge it wont go off as quick and keeps liquid for ages
apologies if you already know this wee trick

[Herr Dr. Professor]

Thanks! There's plenty of room in this old widower's 'fridge, so the super glue is going in pronto.

[Stormbringer]

just keep it upright or in an old plastic container in case it leaks tho
I know as i hadnt put lid on properly and now have a bottle permanently attached to a door tray

[tankme]

I go through my CA glue faster than it can go bad...

[Stormbringer]

ROFL mate

[Panzermechaniker]

I go through my CA glue faster than it can go bad...

Tell me about it. Everytime I touch this 3D Conqueror I'm working on I break/knock off so much stuff I have to order another 15 gram of krazy glue from Amazon right away

[tankme]

Tell me about it. Everytime I touch this 3D Conqueror I'm working on I break/knock off so much stuff I have to order another 15 gram of krazy glue from Amazon right away.

I usually go through at least on of the little tubes just gluing pins in tracks. I've had a few cracks in the Kranvagn by picking it up from the side skirts, but a little MEK and they were good to go again. Kinda the reason I stopped using ASA filament as the layer adhesion wasn't as good as ABS. I also had a resin antenna mount break, but I drilled a hole in the mount bottom and the broken part. I then used a metal rod and CA to fix it.

[HERMAN BIX]

I use a Loctite Gel sits resistant to high impact .
Takes a wee while to set so a degree of manipulation is available.
It’s $10 a bottle and I burn 4 per model on average
It’s a standard purchase if we are out & about, even the kids say “Dad do you need glue while we are out “

https://www.bunnings.com.au/loctite-3g- ... gIhhvD_BwE

[Herr Dr. Professor]

As many of you already know, cyanoacrylate's best holding ability is in line with the joint. Sideways to the joint, or any angle to the joint, the cyanoacrylate is actually quite weak. Whenever feasible, I use "E6000." (I think "Shoo Goo" is the same.) This glue has a slower setting time and as a result actually holds much better in all directions. What is more, it still flexes a bit after completely drying. However, it can also be stringy and is thick, so messing the model a bit is a risk (true of cyanoacrylates, too). Fortunately, E6000 can be sanded and painted. Nonetheless, I do use the Loctite cyanoacrylates, too.

[jarndice]

I try to avoid using glue but when I do I have found GORILLA Superglue to be very effective and it is the first of the various cyannacrylate glue's on the market where I can get the top off of the bottle every time all the way to the bottom of the little bottle.
But where possible I will tap a thread and put a nut and bolt in place or use my Butane torch and Liquid solder using PE.
Many ways to swing a cat without using glue.