Next project on the way

[Sam84]

Hello again,

To everyone on the forum all of the builds that everyone does inspires me and gives me ideas on what to do, I thank each and everyone of you guys. Keep up the good work everyone.

I have started my next two projects the sdkfz 251 which I got off if cults 3d and my Panzer iii of the 24th Panzer division the leaping horsemen of Stalingrad.

Will post more pics as I do both of them, if have any ideas or corrections on these both please let me know and I will try and do my best to fix them .

Again keep up the good work everyone .

IMG_20240318_184810497~2.jpg (1.26 MiB) Viewed 319 times

Many thanks

Sam

IMG_20240318_184817515~2.jpg (2.11 MiB) Viewed 319 times

IMG_20240318_184835728~2.jpg (1.24 MiB) Viewed 319 times

IMG_20240318_184842214~2.jpg (1.25 MiB) Viewed 319 times

IMG_20240318_184848797~3.jpg (2.1 MiB) Viewed 319 times

IMG_20240318_184858547~2.jpg (730.47 KiB) Viewed 319 times

[Meter rat]

Following along with this. Two interesting looking vehicles.

[Martin2556]

Hi Sam, I will be following your new projects, you may find my Panzer III build of interest, link below:

viewtopic.php?t=30246

[Herr Dr. Professor]

I'll be watching, learning, and cheering for you, Sam84.

[Sam84]

Hello everyone,

Well the Panzer iii is almost complete just waiting on some decals and a speaker and some rust paint from Oz armour should be here by end of the week.

Martin 2556 your Panzer iii looks great you did a very good job on her .

I'm going to be running the second ibu2 board through her, just got a few kinks to work out will try and upload a short vid of her running .

I used a mix of printed parts and original parts cut off of it, the track cable is hanging wire with a bit of mig wire hand piece gut cut. Printed the exhaust system and made work from the heat unit.
Use clear plastic in the commanders hatch, and drivers visor.


Started on the crew and doing a bit more to the APC.

Without further ado here she is.

[Martin2556]

Your Panzer III is looking great, well done

[Herr Dr. Professor]

I had never thought of using clear plastic for the visors. As my mother used to say about the obvious that never occurred to me "...been a snake, it woulda bit ya!"