Prepping a 3d print for painting

[Son of a gun-ner]

I have a vague memory of someone recommending bumper paint, because it was thicker than normal, and could contribute to filling in print lines, I'll try and find it

[Tiger6]

Filler Primer and Plastic Primer are my usual goto's, but they take a fair amount of wet sanding to work out the ridges

[tankme]

I want all the lines removed also, as they are not there on the real tank. I can accept a few small ones in little spots, but massive print lines on the side of the tank are a definite "no go at this station."

[Son of a gun-ner]

As promised, this is the way wIbblywobbly does it.
Although I think I'd still give it a bit of a sanding.

Page two.
Russian MB-LT Army Surplus Logging Machine - Page 2 -
viewtopic.php?t=26480&start=10