Elmod and Mato.... help needed

[Tango689]

Hello,

So recently I purchased a Mato M36 and I am trying to install an Elmod FusionX. This is confusing the heck out of me, there seems to be too many wires for some of the connections and the Elmod instructions aren't very clear.

The only things the Mato tank came with is a servo for the gun elevation and recoil, both of these are 3 wire connectors.

Do I need to purchase a Taigen plug for the upper hull? Or should I use a HL adapter and convert it across? It is also saying to use the flash connector component but that doesn't make any sense, it is like the wires are spilt and don't go to the same location?

Any help or diagrams for Mato would greatly apprecieacted, it seems like the only info out there is for Taigen and HL.

Ideally I would like to install flash system with recoil and smoke.

[Jofaur86]

Hello,
To use the servos? you need FX Expander module, attached explanatory note link, otherwise Google is your friend
https://elmod.eu/produkt/fx-expander/?lang=en
https://www.manualslib.com/manual/24921 ... e=4#manual