Newish Chap

[tanker bob]

Hi,

I joined the RCT last October, but then my daughter and family moved in while their extension was built so I was'nt able to do much on the tank converting side, but they have moved out so I can start now, I have been wargaming for years but have packed up now and wanted something new to start, I have always been interested in tanks, and saw these Heng long one's on the net and was hooked, I am an agricultural fitter but I cant really use gas bottles and big hammer on these but there are also 12v electrics on most equipment so that should help.

At the moment I am trying to put RX18 board and I/R receiver unit in my M41 Bulldog which had an RX14 board, I was hopeing someone might be able to help, CN9 does it plug into the existing multi-pin plug in the turret, I suppose everything is still the same, does anybody know where I can get the triple socket and pins to crimp on the wires for the socket from, for the I/R receiver, on the M41 there are the red rear lights where do I plug them in on the RX18, I have been copying off my I/R Stug for most things, also the volume wires on the RX14 there are two red and a Black on the RX18 there are red white and black do you know which way round the red and white go. I must also thank Forgebear for a good service and helping where he can or putting me in contact with somebody who can.


Bob

[wibblywobbly]

Welcome to the forum, you will find the answer here. You may find you get a response if you repeat the post in the General Discussion area, as everyone reads that.

Cheers

Rob G

[BIGMIG]

Hi Tanker Bob,
    Just wanted to say hello and welcome to the forum from the other side of the big pond.
Like Rob G said above just post in the general discussion  --need some help on wiring---and I'm sure you will get the help you need.Can't offer you any help myself as I have not yet used the newer RX 18 board.

                                BIGMIG 

[tanker bob]

Thanks Rob G and BIGMIG, just looked in the electronics section and there might be all the info I need.

[tankmad]

Welcome to the site Bob hope you fixed the tank
Stevie

[tanker bob]

Thanks Stevie, just the turret area to do hope to finnish it at the weekend.

[[ICE]monkey]

hi and welcome to the forum
regards, ice

[happytanker]

good to see you here bob but my opinion is that you never truly finish a work of tanky art, it just keeps getting added to.
but then again i am insane and so are all the gnomes in my head!!!!  

[Saxondog]

Welcome if you need wiring diagrams for rx-18 I have them,but I do believe they are allready posted.Sax