Before it goes on, again a word to the windows. These has been brushed with primer from Tamiya out of the can...
…and thereafter in a dark grey with my airbrush brushed.
Now to the gate, this shall receive two wings, for the construction has been used wooden tongue depressors.
The actual structure of the gate has been constructed from wooden coffee stirrers. These have been on both door wings around 90 degrees turned glued.
Each door wing receive two door hinges;…
…constructed from copper sheet stripes 8 x 0,8 mm. These have been cut to length, bent and welded.
With the door wings it goes on; each receives outside two bars, where the hinges have been mounted.
For the gate wings mount I've glued at each gate post inside a wooden additional bar.
Old furniture eccentrics has been adjusted and used as admission for the gate wings. Off with the head,…
…a hole drilled into it, a thread cut and an eye screw screwed. To completion is missing a piece; for that receive this part later still a bolt from brass.
Four of these parts have been needed. These have been leaded from outside through the Styrodur against the wooden square bar and there with a screw hold.
Further in the next part.