No gun sound and elevation IBU2U

Discuss the IBU2 & IBU3 here.
User avatar
tanker ed
Private
Posts: 60
Joined: Thu Oct 12, 2017 12:17 pm
Location: Ostend Belgium

No gun sound and elevation IBU2U

Post by tanker ed »

Normaly i am a Clark man ,but this time i bought a IBU2U to experiment with and compare to Clark boards.

Everything is working well but i dont have gun elevation and a very poor gun sound like a plop sound than a gun sound.
Engine sound is working very wel also but the Clark TK60 is way better sound wise.
Driving of the tank is better on the IBU2U

What i found out if i reduce the servo travel in travel adjust to 70% the elevation works perfectly but not gun plof sound anymore.

If i bring back my servo travel to 100% elevation gone and the plof sound with a poor BB klap.

My set up is a JR PROPO 28X and a 8channel reciever also from JR
Channel set up 1=Thro 2=AIL 3=Elev 4=Rudder and 5 tro 8 are aux channels

Caliberated a dozen times and the latest Ini. and firmware are on it.

Sound i am using is Tiger I sound.
Taigen Pzkw IV metal edition
Torro Panther F metal edition
HL T90
Taigen TigerI metal edition
HL Torro edition Challenger 2
TigerI Project
Clark-Elmod-Ibu2ultimate
JR28X
User avatar
tanker ed
Private
Posts: 60
Joined: Thu Oct 12, 2017 12:17 pm
Location: Ostend Belgium

Re: No gun sound and elevation IBU2U

Post by tanker ed »

Were are the experts ??????

Thks Ed
Taigen Pzkw IV metal edition
Torro Panther F metal edition
HL T90
Taigen TigerI metal edition
HL Torro edition Challenger 2
TigerI Project
Clark-Elmod-Ibu2ultimate
JR28X
User avatar
Tankbear
Lieutenant
Posts: 3002
Joined: Sun May 22, 2011 12:00 pm
Contact:

Re: No gun sound and elevation IBU2U

Post by Tankbear »

Elevation might be because you have some mixer setup on the radio.

Never known no gun sound unless it’s not firing which might be the case if the elevation isn’t working correctly as it’s all on the same rc channel.
www.mad-tanks.weebly.com
www.rctankelectronics.com
www.rc-truck.weebly.com
www.rc-boat.weebly.com
User avatar
tanker ed
Private
Posts: 60
Joined: Thu Oct 12, 2017 12:17 pm
Location: Ostend Belgium

Re: No gun sound and elevation IBU2U

Post by tanker ed »

Dont think any mixing is active on the radio wil check to make shure.Its strange i have to lower my elevetion travel adjust to 70% to make my elevation work.


My radio is working perfect on al my clark boards.
Taigen Pzkw IV metal edition
Torro Panther F metal edition
HL T90
Taigen TigerI metal edition
HL Torro edition Challenger 2
TigerI Project
Clark-Elmod-Ibu2ultimate
JR28X
User avatar
Tankbear
Lieutenant
Posts: 3002
Joined: Sun May 22, 2011 12:00 pm
Contact:

Re: No gun sound and elevation IBU2U

Post by Tankbear »

The IBU2U self learns the channels, reverse and range during calibration so something must be confusing it which is normally mixing of channels
www.mad-tanks.weebly.com
www.rctankelectronics.com
www.rc-truck.weebly.com
www.rc-boat.weebly.com
User avatar
tomhugill
Captain
Posts: 4745
Joined: Thu Apr 15, 2010 11:21 am

Re: No gun sound and elevation IBU2U

Post by tomhugill »

Sounds like your struggling to hit the elevation window on the stick. If you reduce the travel that window becomes bigger but then youve reduced the stick travel to the extent you can't fire the main or machine guns. What I do is run a mix so the stick travels the extent of the elevation trigger and then put the mg and main gun onto switches with another mix
User avatar
tanker ed
Private
Posts: 60
Joined: Thu Oct 12, 2017 12:17 pm
Location: Ostend Belgium

Re: No gun sound and elevation IBU2U

Post by tanker ed »

If lowering the travel adjust elevation is working just fine .

No mixings are on everything is INH ,normaly if i make a new model and bind no mixings are active on my Radio

How can i put the Gun and MG on a switch
Taigen Pzkw IV metal edition
Torro Panther F metal edition
HL T90
Taigen TigerI metal edition
HL Torro edition Challenger 2
TigerI Project
Clark-Elmod-Ibu2ultimate
JR28X
User avatar
tomhugill
Captain
Posts: 4745
Joined: Thu Apr 15, 2010 11:21 am

Re: No gun sound and elevation IBU2U

Post by tomhugill »

tanker ed wrote:If lowering the travel adjust elevation is working just fine .

No mixings are on everything is INH ,normaly if i make a new model and bind no mixings are active on my Radio

How can i put the Gun and MG on a switch
You'll need to use mixing on your radio!
User avatar
tanker ed
Private
Posts: 60
Joined: Thu Oct 12, 2017 12:17 pm
Location: Ostend Belgium

Re: No gun sound and elevation IBU2U

Post by tanker ed »

Wich mixing ? there are a lot on my radio
Taigen Pzkw IV metal edition
Torro Panther F metal edition
HL T90
Taigen TigerI metal edition
HL Torro edition Challenger 2
TigerI Project
Clark-Elmod-Ibu2ultimate
JR28X
User avatar
tanker ed
Private
Posts: 60
Joined: Thu Oct 12, 2017 12:17 pm
Location: Ostend Belgium

Re: No gun sound and elevation IBU2U

Post by tanker ed »

i have taken my old JR radio and Elevation is ok now and the gun fires but still a very weak gun sound like a dull plof sound track recoil works fine

Stil a very weak gun sound and the MG even weaker
Taigen Pzkw IV metal edition
Torro Panther F metal edition
HL T90
Taigen TigerI metal edition
HL Torro edition Challenger 2
TigerI Project
Clark-Elmod-Ibu2ultimate
JR28X
Post Reply

Return to “IBU2 / IBU3”