

ALPHA
not really in the biz,just wanted a fpv setup that was cheap and portable.a typical setup cost around $500 to buy.i built this setup for under $150 but i already had the moniter....a used headrest 7 in dvd player.ALPHA wrote:WoW!!!...That's some set up you got there igotit...you in the AV biz
![]()
ALPHA
I've just bought a 2.4G Leo2a6. Production date is May 2015 and has trim. As I test drive, the tank move fine though not great. I dont know what version that 2.4g is. How can I check? The tank come with 1800mah li.ion battery. Not sure if it would pass custom check or not. I'm still in Thailand.ALPHA wrote:Is yours the 2.4 version?....If not...does your controller have trims....found messing with the adjustments helped quite a bit in slow maneuvering ....The downside is I'm pretty sure HL removed the trim on the later models ...on the second gen 2.4 they are gone also...interestingly enough...they put one back on the 3rd gen 2.4
really sensitive....but on the M1 it helps a lot....![]()
ALPHA
igotit wrote:Thanx for sharing that thread and vid max.
Ive unplugged the signal wire from airsoft unit to mfu....this eliminated track recoil when the airsoft is fired.
What you have is probably the 3rd Gen Steel....the way you can tell is if it is the 3rd gen is by the general appearance....the 3rd gen TX is rounded and smooth all over....where the 1st and 2nd is square like the old 27 mhz models but with no antenna and no crystal portSteelBird wrote:I've just bought a 2.4G Leo2a6. Production date is May 2015 and has trim. As I test drive, the tank move fine though not great. I dont know what version that 2.4g is. How can I check? The tank come with 1800mah li.ion battery. Not sure if it would pass custom check or not. I'm still in Thailand.ALPHA wrote:Is yours the 2.4 version?....If not...does your controller have trims....found messing with the adjustments helped quite a bit in slow maneuvering ....The downside is I'm pretty sure HL removed the trim on the later models ...on the second gen 2.4 they are gone also...interestingly enough...they put one back on the 3rd gen 2.4
really sensitive....but on the M1 it helps a lot....![]()
ALPHA
I like what I see...everything is well thought out and easily transported....you must take some video and post it...igotit wrote:not really in the biz,just wanted a fpv setup that was cheap and portable.a typical setup cost around $500 to buy.i built this setup for under $150 but i already had the moniter....a used headrest 7 in dvd player.ALPHA wrote:WoW!!!...That's some set up you got there igotit...you in the AV biz
![]()
ALPHA
most use small lipos to power up the moniter and reciever,i used a $11 12v sla battery that provides 9 hours of run time.....the downside is the battery is 5 lbs.
this camera is a cm205 unit,$20 and has built in vid transmitter,3/8 x 3/8 x 1.5 in....made to be installed as a hidden type spy cam.
its cheap and efficent to run.....its dowside is short range and has poor visibility in low light conditions.