Page 1 of 2
Abrams
Posted: Fri Mar 14, 2025 5:11 pm
by Rockape63
I recently purchased a Heng Long Abrams Proffesional Edition. The battery bay and power switch are accessable on top of the hull. I was going to upgrade the smoker but when I looked at the 6 screw holes underneath the tank, they are all sealed up. Are the screws inserted from the top of the hull like the new Merkava? Any ideas?
Re: Abrams
Posted: Fri Mar 14, 2025 5:41 pm
by tankme
News to me. Never seen that version.
Re: Abrams
Posted: Fri Mar 14, 2025 6:00 pm
by Rockape63
Re: Abrams
Posted: Fri Mar 14, 2025 6:21 pm
by Rockape63
Battery bay
Re: Abrams
Posted: Fri Mar 14, 2025 6:22 pm
by Rockape63
Power switch
Re: Abrams
Posted: Fri Mar 14, 2025 10:55 pm
by Meter rat
Also news to me. Never seen this version, especially with bits missing from either side of the drivers compartment.
Spud WIP had a similar question in his introduction.
Oh! And a very belated welcome from Argyll and Bute.
Re: Abrams
Posted: Sat Mar 15, 2025 7:45 am
by Rockape63
Thanks and Hello from Elgin
Re: Abrams
Posted: Tue Mar 18, 2025 10:08 am
by Aussie
Meter rat wrote: ↑Fri Mar 14, 2025 10:55 pm
especially with bits missing from either side of the drivers compartment.
The "bits" are not missing as such , it's one large panel that lifts out , from my interpretation of the image , anyway.
Re: Abrams
Posted: Tue Mar 18, 2025 10:20 am
by Aussie
Is it pre weathered?
Re: Abrams
Posted: Tue Mar 18, 2025 10:56 am
by Rockape63
Aussie wrote: ↑Tue Mar 18, 2025 10:20 am
Is it pre weathered?
It was but I added some wash and pigment