Taigen V3
-
- Warrant Officer 1st Class
- Posts: 1663
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Taigen V3
Hello
Following the purchase of a Taigen V3 type module,to replace the original RX 18,and use wiht a conventionel radio (Flishky FS6 T ) as indicated? nothing happens and moreover no help,thank king you in advance good day.
PS: no explanatory note
Following the purchase of a Taigen V3 type module,to replace the original RX 18,and use wiht a conventionel radio (Flishky FS6 T ) as indicated? nothing happens and moreover no help,thank king you in advance good day.
PS: no explanatory note
-
- Warrant Officer 1st Class
- Posts: 1663
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Taigen V3
Hello,
No one hase the answers or already had this problem
No one hase the answers or already had this problem
Re: Taigen V3
Did you put the little bind plug in?Jofaur86 wrote:Hello,
No one hase the answers or already had this problem
-
- Warrant Officer 1st Class
- Posts: 1663
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Taigen V3
OK,thank you for the answer but that doesn't tell me why the deck doesn't power the RX? While the fan is running
-
- Warrant Officer 1st Class
- Posts: 1663
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Taigen V3
Tomhugill
Yes
Yes
-
- Warrant Officer 1st Class
- Posts: 1663
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Taigen V3
I do not understand ? Already watched this vidéo,they use a RX Flysky ,but a Taigen transmitter
-
- Warrant Officer 1st Class
- Posts: 1663
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Taigen V3
Thank you for diagram !! I have to connect according to diagram??but my concern is that the fan turns ?and that on my receiver the led does not ligth ? up and that everything works, with servos ? Moreover i do not understand that on the vidéo?a Taigen transmitter is used so I would like to know if it works with a radio set other than Taigen ? And why my RX does not turn on
Re: Taigen V3
connect as in diagram put in your transmitter selection plug number 1 in diagram your rx should be power by the taigen board as it says it has a built in bec if not then i dont know