Hi. I’m new to this rc business (3 years) and have two tanks. My problem is with my Taigen IR Panzer III which won’t fire the high intensity light. I know nothing about electronics, so I am hoping to get specific answers to my specific question. There is a blue wire in the turret to hull cable that is not connected at either end. What do the ends fit into. There is a large red wire that comes out of the turret that is not plugged into anything. Where does that go? There is also a black wire that comes out of the V3 motherhood, where does that go? I have also been told to add another black wire to the on/off switch, but not told what to connect it to.
Your help much appreciated.
Taigen wiring
- Kaczor
- Warrant Officer 1st Class
- Posts: 1772
- Joined: Fri May 18, 2018 9:58 am
- Location: Ciechanow, Poland
- Contact:
Re: Taigen wiring
Probably it's ground wire. It should be connected with wire from motherboard.
- Attachments
-
- 34b0513e9627664b72fac5cced5f8fb2.jpg (92.13 KiB) Viewed 946 times
Re: Taigen wiring
Best to do an introduction first rather than hello i have a problem before someone jumps in and starts having a go. You will find you get more help that way.
Then look at what the tank is doing does the gun recoil when fired and make the gun firing sound ? if not its not triggering the micro switch
Does the turret have 360 rotation ? if so it changes the colour of the wires
Then look at what the tank is doing does the gun recoil when fired and make the gun firing sound ? if not its not triggering the micro switch
Does the turret have 360 rotation ? if so it changes the colour of the wires