I think there is confusion? the video shows a modification of an Asiatam system? which is not the case. the concern is that it is the new system from Taigen, which in order to make disassembly easy, used connectors instead of soldering as originally. This must work on HL, but in this case, not simple without taking part of the wiring
1: signal wire, taken from the barrel recoil switch, rearmost pin
2: platinum power supply, from small inter-general plug
3: link to the reversing servo,
Operating principle: during the barrel recoil it is sent more than 5 volts on this plate, which converts this into a signal for the servo. the 3-pin plug (red, black, black) is the gun elevation and firing motors, the red one Being common and black each engine, schematic attached. Hope I'm clear, and sorry for my poor English.
wiring,Simplified rewiring of HL Part 1
Re: Simplified rewiring of HL Part 1
Thanks for the great and detailed reply - I will get to this ASAP and will post the results
-
- Warrant Officer 1st Class
- Posts: 1665
- Joined: Tue Dec 25, 2018 11:28 pm
- Location: Centre France
Re: Simplified rewiring of HL Part 1
can you do this photo again? clearer and sharper, in order to better see the existing connector? is that your top frame? there is only the turret which is Taigen? if this is the case, should be simpler for the resumption of the wiring
Re: Simplified rewiring of HL Part 1
Hope these help?
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Simplified rewiring of HL Part 1
Sent from my iPhone using Tapatalk
Re: Simplified rewiring of HL Part 1
Sent from my iPhone using Tapatalk
Re: Simplified rewiring of HL Part 1
Sent from my iPhone using Tapatalk
Re: Simplified rewiring of HL Part 1
Sent from my iPhone using Tapatalk
Re: Simplified rewiring of HL Part 1
These pictures are the original HL wiring
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk