Just wonder, can anyone help here.
I have a Fusion Pro and everything works well accept the aux MG output..... ive tried to configer in the elmod config software, but no joy. Its all wired up correctly to the LED and works with a 3v battery supply........any ideas???
Im using a Flysky-i6s TX with a 10 ch RX.
Thanks
Gary
Aux MG output
Aux MG output
Take care..........Gary
Re: Aux MG output
Do you get any sound out of the board for the aux mg?
Re: Aux MG output
Sorry for the late reply, no sound......not even sure which channel it works from.
Gary
Gary
Take care..........Gary
Re: Aux MG output
I would start by double checking where you have it plugged into the board and that the polarity is correct as those plugs are easy to connect the wrong way round. Then have a look at page 8 in the manual. Channel 5 needs to be set to AUX and then it's down on channel 4. If you are getting no sound and have that configured in the app then it's not being triggered on the radio.
Re: Aux MG output
Many thanks for that I’ll give that a try later on....
Gary
Gary
Take care..........Gary
Re: Aux MG output
Thanks for your help.....yes if I had read the instructions in the first place, would have been up and running long ago,
Thanks again Gary
Thanks again Gary
Take care..........Gary
Re: Aux MG output
I've done the same thing myself many times and likely will again. Even with the manual I sometimes run into trouble with these things from time to time so don't hesitate to ask if you have any issues. It's always easier if someone can at least point you in the right direction.