Page 1 of 1

Just saying hello

Posted: Sun Mar 29, 2020 12:49 pm
by Oscardog
I have just joined and this is to say hello to everyone :wave: . I am currently 3D printing a T35A Russian Tank. So if anyone has any advice on how to make the Turrets work and the type of radio system, all help would be appreciated.

Kind regards

Oscardog

Re: Just saying hello

Posted: Sun Mar 29, 2020 3:41 pm
by Son of a gun-ner
Hello and welcome to the forum Mr Oscardog :wave:

Are you intending to print the whole tank?
It may pay you to look at this.

3D Printed T-35A - RC Tank Warfare
viewtopic.php?f=33&t=24871

Re: Just saying hello

Posted: Sun Mar 29, 2020 3:44 pm
by c.rainford73
Greetings Oscar where are you from? Welcome aboard

Re: Just saying hello

Posted: Sun Mar 29, 2020 6:18 pm
by Oscardog
Hi All
Yes I have seen them and I am about to finish the hull, but need help in where all the servos go and how to install them. will put up some photos when I work out how to do it
Oscardog