Convertion to RC PzKpfw 38(T) Panda - Part 2

[eder1969]

Hey guys.
Now the project is more advanced......but there is a lot of work ahead....


















A little tired here....

See two videos in Facebook:
https://www.facebook.com/10000862987582 ... 0051649965

https://www.facebook.com/10000862987582 ... 0168316620

Hugs....

[Kaczor]

Why separate thread?

[jarndice]

I do like your build especially the use of Brass hinges,
I think the hardest part of using metal hinges is what size bolts to use, For instance I always fit metal hinges on the front fenders of my Panzer 4s but it is too easy to fit too big a bolt which looks awful when a smaller bolt adds to the build and your build looks right

[General Jumbo01]

I use metal hinges but prefer to use glue to fit them and then add fake bolt heads. For me, the issue is finding hinges that are to scale and correct shape. Some can be cut to shape if you use a very small cutting disk. I also prefer the flush hinge type.

Nice to see operating doors / flaps on your model.

[eder1969]

I do like your build especially the use of Brass hinges,
I think the hardest part of using metal hinges is what size bolts to use, For instance I always fit metal hinges on the front fenders of my Panzer 4s but it is too easy to fit too big a bolt which looks awful when a smaller bolt adds to the build and your build looks right

Thankyou!

[eder1969]

Why separate thread?

I did not understand your question.
Can be more specific?

[eder1969]

I use metal hinges but prefer to use glue to fit them and then add fake bolt heads. For me, the issue is finding hinges that are to scale and correct shape. Some can be cut to shape if you use a very small cutting disk. I also prefer the flush hinge type.

Nice to see operating doors / flaps on your model.

Hello. These hinges are 1/16 scale but I made some adjustments.
I pasted it and now I'm going to put the screws. Thanks.