VBL Panhard
Posted: Wed Feb 06, 2019 4:25 pm
good Morning,
It goes ahead with the small sample model on the WPL. the tail section is still missing, some adjustments to the frame and to the front bodywork are gone with the sample print, the rear part is finished and all parts glued.
Unfortunately, when I shorten the frame a wrong cut happened, so first the printer started to manufacture a spare part.
so again a little bit geschaft.
on the one hand, the window openings in the doors were changed, they were too big and the window was in the wrong place in the rear door. Then I once drew the ventilation cover for the hood. Here's a video of an impression of how it continues. Today I noticed that the window cutouts are too big for the windshields, because I have to ran on all cases again.
weiter mit dem probedruck, das heckteil ist fertig und alle teile verklebt.
leider ist mir beim rahmen kürzen ein falscher schnitt passiert, also erstmal den drucker angeworfen um ein ersatzteil zu fertigen.
Video
testfahrt
alte Hecktür
neue Hecktür
3D video
It goes ahead with the small sample model on the WPL. the tail section is still missing, some adjustments to the frame and to the front bodywork are gone with the sample print, the rear part is finished and all parts glued.
Unfortunately, when I shorten the frame a wrong cut happened, so first the printer started to manufacture a spare part.
so again a little bit geschaft.
on the one hand, the window openings in the doors were changed, they were too big and the window was in the wrong place in the rear door. Then I once drew the ventilation cover for the hood. Here's a video of an impression of how it continues. Today I noticed that the window cutouts are too big for the windshields, because I have to ran on all cases again.
weiter mit dem probedruck, das heckteil ist fertig und alle teile verklebt.
leider ist mir beim rahmen kürzen ein falscher schnitt passiert, also erstmal den drucker angeworfen um ein ersatzteil zu fertigen.
Video
testfahrt
alte Hecktür
neue Hecktür
3D video