Challenger 1 soundset for clark boards

Discussion for Clark electronics.
Stevemcc
Recruit
Posts: 10
Joined: Sat Apr 03, 2021 10:13 pm
Location: UK, Norfolk

Re: Challenger 1 soundset for clark boards

Post by Stevemcc »

Hi,

Done.

The board is on its way back to Clark today to exchange for a TK80S

Thanks
Tamiya KT Full Option
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
Stevemcc
Recruit
Posts: 10
Joined: Sat Apr 03, 2021 10:13 pm
Location: UK, Norfolk

Re: Challenger 1 soundset for clark boards

Post by Stevemcc »

Hi,

TK80s now installed and working ok (s-bus)

I had a rotating beacon led already installed that worked off/ is wired as a servo input direct to the previous receiver i.e. has the 3 wires because it has multi flashing modes.

Any thoughts on how best to connect this into the TK80 board? I.d like to retain the multi modes if possible.

Another question - can the esc start and the engine sounds be better synchronised? I've reduced the esc start volatage by half and its maybe a little better but is there a better way?

Thanks once again for the sound set - its really good, especially the gear change.

Steve
Tamiya KT Full Option
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
Stevemcc
Recruit
Posts: 10
Joined: Sat Apr 03, 2021 10:13 pm
Location: UK, Norfolk

Re: Challenger 1 soundset for clark boards

Post by Stevemcc »

DSC_0403~01.jpeg
DSC_0403~01.jpeg (80.95 KiB) Viewed 1478 times
Tamiya KT Full Option
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
Post Reply

Return to “Clark”