Hi,
Done.
The board is on its way back to Clark today to exchange for a TK80S
Thanks
Challenger 1 soundset for clark boards
Re: Challenger 1 soundset for clark boards
Tamiya KT Full Option
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
Re: Challenger 1 soundset for clark boards
Hi,
TK80s now installed and working ok (s-bus)
I had a rotating beacon led already installed that worked off/ is wired as a servo input direct to the previous receiver i.e. has the 3 wires because it has multi flashing modes.
Any thoughts on how best to connect this into the TK80 board? I.d like to retain the multi modes if possible.
Another question - can the esc start and the engine sounds be better synchronised? I've reduced the esc start volatage by half and its maybe a little better but is there a better way?
Thanks once again for the sound set - its really good, especially the gear change.
Steve
TK80s now installed and working ok (s-bus)
I had a rotating beacon led already installed that worked off/ is wired as a servo input direct to the previous receiver i.e. has the 3 wires because it has multi flashing modes.
Any thoughts on how best to connect this into the TK80 board? I.d like to retain the multi modes if possible.
Another question - can the esc start and the engine sounds be better synchronised? I've reduced the esc start volatage by half and its maybe a little better but is there a better way?
Thanks once again for the sound set - its really good, especially the gear change.
Steve
Tamiya KT Full Option
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
Re: Challenger 1 soundset for clark boards
Tamiya KT Full Option
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90
HL Leo 2A5
Taigen T34/85
HL PzKw 3/ Stug 3
HL Panther G
HL Chall 2
HL T-72/ T-90