HvyCgn9 wrote:Actually nearly went up to Bunnings when I knocked off from work....but then I got sidetracked!!
Will have a look next time I'm in there,I've got some brass mesh for my ship building but its much to fine for the tank, also have some stainless steel TERMI mesh that a mate gave me but its also to fin a mesh for the tank.
Going to replace the HL 0.50 and 0.30 with these from Shapeways: (the 1/16 version)
https://www.shapeways.com/product/P3LQZ ... d=62271464
I though I would let you know,
I just received mine and the execution/engineering is very well done. I can not say the same for the print quality. The surface finish is akin to 100 grit or heaver sand paper.
The flat surfaces "could" be sanded smooth but there is so much detail on the machine guns and other parts that it will be impossible to clean them up enough for use without destroying all the detail.
The is only one print medium available and that is "White Strong and Flexible" unlike the Bustle Extension and Water Cans which are available in "Frosted Ultra" and "Frosted Extreme Detail" print medium.
The Bustle Extension is very well done and the detail is very good same for the Water Cans.
The Bustle Extension is not as flexible as the Gun set but IMO flexible enough.
Barry