IBU 2 woes
- Docomar750
- Private
- Posts: 66
- Joined: Mon Sep 14, 2015 10:35 am
- Location: Northamptonshire
IBU 2 woes
Hi All
Got my sherman in the garden this afternoon and happily driving away then it just died battery voltage good power getting through switch to board just no life in the board?
Any ideas I can check board is an old ibu2 green board
Got my sherman in the garden this afternoon and happily driving away then it just died battery voltage good power getting through switch to board just no life in the board?
Any ideas I can check board is an old ibu2 green board
- c.rainford73
- Major
- Posts: 6104
- Joined: Thu Aug 25, 2016 7:34 pm
- Location: Connecticut USA
Re: IBU 2 woes
Did you check the fuses? There's one small one and a large one if i remember....
Tanks alot....
- Docomar750
- Private
- Posts: 66
- Joined: Mon Sep 14, 2015 10:35 am
- Location: Northamptonshire
Re: IBU 2 woes
Hi
Yes check big one the small one I think is soldered to the board not 100% sure about that one on testing as getting a spike then meter reads zero
Yes check big one the small one I think is soldered to the board not 100% sure about that one on testing as getting a spike then meter reads zero
- midlife306
- Warrant Officer 1st Class
- Posts: 2238
- Joined: Sun Aug 27, 2017 10:34 am
Re: IBU 2 woes
I’ve had the same thing happen with mine, usually switch off & switch back on does the trick, tbh I think my motors are close to the boards limits, it is quite a heavy Tiger 1 lol
Cheers
Wayne
Sent from my iPhone using Tapatalk
Cheers
Wayne
Sent from my iPhone using Tapatalk
Re: IBU 2 woes
seems to quite a lot of IBU 2's going tits up lately ?
- c.rainford73
- Major
- Posts: 6104
- Joined: Thu Aug 25, 2016 7:34 pm
- Location: Connecticut USA
Re: IBU 2 woes
Silly question are the radio batteries good and is the radio properly calibrated? Has the tank been run a bit lately or sitting for a while.....
Does the board light up when powered up or no action at all?
Does the board light up when powered up or no action at all?
Tanks alot....
- Docomar750
- Private
- Posts: 66
- Joined: Mon Sep 14, 2015 10:35 am
- Location: Northamptonshire
Re: IBU 2 woes
Hi
It's not run for a while as other projects on going cleared all dust out with compressed air (no moisture I have filter on compressor) and the board does nothing no light no sound.
It's not run for a while as other projects on going cleared all dust out with compressed air (no moisture I have filter on compressor) and the board does nothing no light no sound.
- spongehoobtank82
- Sergeant
- Posts: 610
- Joined: Fri Aug 08, 2014 1:23 am
Re: IBU 2 woes
If nothing comes on It will be the small 2amp SMD fuse that's blown, it is removable with I very small flat head screwdriver, you should be able to get some more from Ian at rctank electronics. Hope that helps dude
Sponghoobtank82-panzerIII, panther V, tiger VI early and late and another early tiger,leopard 2a6, panzer IV F2,challenger 2
Re: IBU 2 woes
Before you use screwdrivers and solder irons, please remove the battery, use a multimeter (use ohm meter): measure resistance on both ends of the fuse. It should be zero Ohms if the fuse is intact. If the resistance is infinite than the fuse is broken. In that case follow the advice from spongehoobtank82. But I think you already did. Does the led /light on the receiver burn or does the board receiving power (multimeter) ?Are the tracks blocked (grass between the tracks)? Or try this: disconnect the the multi-coloured turret/gun/machine-gun connector and. see what happens than (maybe there is a short in that part of the tank causing a faulty board.
cheers Easy 8
cheers Easy 8
- Docomar750
- Private
- Posts: 66
- Joined: Mon Sep 14, 2015 10:35 am
- Location: Northamptonshire
Re: IBU 2 woes
Well thats 4 fuses on the board burnt out have plugged and unplugged servos, recoil and high intensity flash and still can't trace what is blowing the fuse just got a dead board and don't want to buy anymore fuses fed up now looks like will need new board