ibu2 and lipo battries
-
- Recruit
- Posts: 33
- Joined: Sun Sep 17, 2017 10:19 pm
ibu2 and lipo battries
Hello im new to the rc world and have just been in receipt of a used tiger by taigen with an ibu2 board ,need to know if the ibu2 base 1.10version needs a lipo battery,it all worked well when I first recieved it but the battery(nicad) went flat and after a full charge and refitting now it wont go through the starting procedure everything else works turret,barrel machine gun main gun etc, the green light is flashing so all is good just no start up any advice would be greatfully received
- Raminator
- Warrant Officer 2nd Class
- Posts: 1267
- Joined: Tue Aug 11, 2015 9:57 am
- Location: Newcastle, Australia
Re: ibu2 and lipo battries
The base IBU2 will run fine on both NiMH and 2S LiPo. If the turret and guns work, have you successfully started the motor? By default, you need to hold the left stick in the bottom-right corner for at least 5 seconds. If some of your channels have changed or been reversed, you might need to try some of the other corners.
Re: ibu2 and lipo battries
Ibu2 base will also handle 3s just fine.
-
- Recruit
- Posts: 33
- Joined: Sun Sep 17, 2017 10:19 pm
Re: ibu2 and lipo battries
no the tank wont start up, so there is no drive to the tracks all the turret stuff works,just no start up
Re: ibu2 and lipo battries
Battery below cut if voltage if using a 7.2 make sure battery voltage isn't set to 11.3
Re: ibu2 and lipo battries
Agree with tomhugill, also I would try a new radio calibration (using dip-switch n°8), it's possible when running the battery until "dead" that board data memory get corrupted.
-
- Recruit
- Posts: 33
- Joined: Sun Sep 17, 2017 10:19 pm
Re: ibu2 and lipo battries
Hello, arnt all the nicads/nimh batteries 7.2, this is what i thought, not sure what you mean by "battery below cut", so if the battery is pumping out a voltage less than , 7.2 it wont start ,is this cut of for lipo protecton,i have noticed that some lipos are actually 7.4 could the voltage be changed with the transmitter by accident do you know at what voltage the ibu2 stops the tank from starting as i say im new to this
-
- Recruit
- Posts: 33
- Joined: Sun Sep 17, 2017 10:19 pm
Re: ibu2 and lipo battries
dip switches 1and2 are in the up position all the rest are the down position is this correct
Re: ibu2 and lipo battries
Don't know off the top of my head, read the manual.anglosaxon wrote:dip switches 1and2 are in the up position all the rest are the down position is this correct
Should be set to NiMH and 7.2v/2s voltage
-
- Recruit
- Posts: 33
- Joined: Sun Sep 17, 2017 10:19 pm
Re: ibu2 and lipo battries
Cheers all sorted now, the fault lay in the charger