Channel Mixing
Channel Mixing
I want to move the cannon fire and MG fire to their own switches. I know its possible through channel mixing but I no very little about it. I have a IBU2U with a Flysky i6x Any help would be appreciated.
Re: Channel Mixing
Here is how I think it works;
Channel 2 being the barrel up or down.
Channel 8 main gun
Channel 9 MG
Change the high end point of CH2 to 75%-80% (need to experiment where the cutoff is)
Change the low end point of CH2 to 75%-80% (need to experiment where the cutoff is)
Master CH8 Slave CH2 100% POS mix
Master CH9 Slave CH2 100% NEG mix
Does that look correct?
Channel 2 being the barrel up or down.
Channel 8 main gun
Channel 9 MG
Change the high end point of CH2 to 75%-80% (need to experiment where the cutoff is)
Change the low end point of CH2 to 75%-80% (need to experiment where the cutoff is)
Master CH8 Slave CH2 100% POS mix
Master CH9 Slave CH2 100% NEG mix
Does that look correct?
Re: Channel Mixing
Yes, correct, some test as you right said about the end point are needed, i think 70% should work just fine.
Remember to calibrate the board before add mixing.
Let us know …
Remember to calibrate the board before add mixing.
Let us know …
Re: Channel Mixing
The mixing seemed to work but the end points not so much.
I do not want moving the stick on CH2 to trigger either guns. If I adjust CH2's end points to 70% it affects the mixing as well on CH8. Triggering CH8 gives 100% of CH2 that has the end point set at 70%.
I am thinking if there was some way the triggering CH8 could give 130% of CH2 that would take care of it. Unfortunately the mixing settings wont let me go above 100%. I can adjust the end points to 120% did not seem to fix it. Also, moving the offset of CH2 did not correct it either.
lol Is that clear??
I do not want moving the stick on CH2 to trigger either guns. If I adjust CH2's end points to 70% it affects the mixing as well on CH8. Triggering CH8 gives 100% of CH2 that has the end point set at 70%.
I am thinking if there was some way the triggering CH8 could give 130% of CH2 that would take care of it. Unfortunately the mixing settings wont let me go above 100%. I can adjust the end points to 120% did not seem to fix it. Also, moving the offset of CH2 did not correct it either.
lol Is that clear??