Good afternoon
I'm hoping to pick your brains if I may.
I have plugged the Tamiya recoil unit into the ibu and the barrel recoils and returns constantly.All other functions work perfectly.
Is there a setting in the ibu or is the plug wired wrong.
Cheers
Del
Ibu2 pro and Tamiya recoil problem
Re: Ibu2 pro and Tamiya recoil problem
Is the micro switch working?
Re: Ibu2 pro and Tamiya recoil problem
I will test it to be sure but it was working fine when I unplugged it from the Tamiya dmd
-
- Warrant Officer 2nd Class
- Posts: 1210
- Joined: Wed Sep 17, 2014 4:00 pm
- Location: Roseville, CA.
Re: Ibu2 pro and Tamiya recoil problem
I had the same problem with two IBU2's and two different recoil units, never did sort it out, micro switch is not the problem.Del wrote:I will test it to be sure but it was working fine when I unplugged it from the Tamiya dmd
Joe
Re: Ibu2 pro and Tamiya recoil problem
I think is a recoil wiring problem, try to swap the outer wires letting the center wire where it is now.
Re: Ibu2 pro and Tamiya recoil problem
I have tried that bud,it did the same thing just constantly runningtheibuman wrote:I think is a recoil wiring problem, try to swap the outer wires letting the center wire where it is now.
Re: Ibu2 pro and Tamiya recoil problem
Change the timings on the microSD card, it's something like
Tamiyarecoil=1500
Change to 300-500
Basically the timing also does the airsoft timing and as most customers use airsoft I send IBU out with default settings for airsoft.
Ian
Tamiyarecoil=1500
Change to 300-500
Basically the timing also does the airsoft timing and as most customers use airsoft I send IBU out with default settings for airsoft.
Ian
www.mad-tanks.weebly.com
www.rctankelectronics.com
www.rc-truck.weebly.com
www.rc-boat.weebly.com
www.rctankelectronics.com
www.rc-truck.weebly.com
www.rc-boat.weebly.com
Re: Ibu2 pro and Tamiya recoil problem
Thanks Ian
Re: Ibu2 pro and Tamiya recoil problem
After much head scratching it's now sorted,the Ibu is switching the polarity on the Tamiya unit spinning it backwards and because of the slop that causes in the unit because of the worm gear the micro switch isn't depressed fully.switch the polarity on the motor and alls good